Best assembly and supply chain firm in Denver CO? Alfred Manufacturing Corporation’s Engineering Services enables AMC to provide design solutions and processes that address your needs from cradle to grave. Our product development capabilities range from simple to very complex; from a simple part to a highly sophisticated system. Our in-house staff provides the execution phase of your project based on continuous collaborative, synergistic integration of engineering and manufacturing expertise. We’re made up of individuals who take their craft seriously, and who collaborate with each other and our customers.
Anneal your metal by heating to a dull red and allow to cool (unless your metal has already been annealed, as is the case with our range of pre-cut stamping blanks). Support the metal fully from the reverse, using a steel block or sandbag. Measure and mark the position where you would like the impression to sit (ImpressArt Stamp Straight Tape is useful for this step. Hold your chosen stamp in place (with your left hand if you are right handed, or your right hand if you are left handed) ensuring that it stands fully upright, with the whole design in complete contact with the surface of the metal. Take your hammer and get your position by resting it on the top of the stamp, ready to strike. When ready, raise the hammer and strike the end of your stamp cleanly and with strength. If you feel you need a second blow, ensure you DO NOT MOVE the stamp or this will ruin your design. The force of the blow will determine the depth of the impression. Designs can be enhanced by rubbing over with a black marker pen or stamping enamel ink, and then buffing off the excess from the remaining raised areas.
Customers benefit from Alfred’s full line of machine tools that are programmed, set up and operated by the best craftsmen in the industry. We have experience in supplying the Aerospace, Automotive, Military and Commercial Industries, and we have perfected the appropriate systems and procedures to successfully serve each demanding industry with the correct level of QA. Excelling at prototypes and effective with high volume production runs, no job is too small or too large. We simply match the demand and do what it takes with the equipment necessary to be successful. See more information at metal stamping.
Are you concerned about domestic or foreign products? The answer to this question varies, there are advantages and disadvantages to each. It also depends on your product description. Regardless of the product type, you will need to consider other options such as speed, balance cost and quality. Additionally, identify your needs; products with assembly will not be expensive abroad because labor rates are lower, but the main concern is the cost of the shipping crate. You also need to consider shipping and other duties.
3 generations of the Alfred family have worked on creating a firm that has become one of the most diversified manufacturing organizations in the nation. Determined to assemble the strongest team while investing in current technologies and facilities’ all while maintaining a healthy balance sheet. Alfred Manufacturing is equipped to deliver your manufacturing requirements. No job is too small or too big, and Alfred’s manufacturability engineers and 120+ person production team will take care of you. Discover extra info on https://www.alfredmfg.com/.